Kit hybride éolien et solaire 12v 230V 720W soit 4320w/jour

The energy produced by this 12V "wind and solar" hybrid kit allows you to power your applications in isolated sites (autonomous hybrid kit for applications not connected to the electrical grid) (Example of application: telecommunication site, isolated or autonomous housing, water pumping, mobile leisure on boat, camper van…).

700W Hybrid Kit including:

• 1 wind turbine type Air-PROSPEED 12V 420W 35A
• 3 photovoltaic solar panels of 100W system in 12V (Dimensions 1190 x 540 x 35 mm)
• 1 solar charge controller FPS-STECA 12V/24V 30A
• 1 inverter (pure sine wave) 1000W 12V/230V
• 2 x 5 meters of solar cable
• Total weight: 45.00 Kg

The set does not include the mast or the batteries.

Product description:

- 1 wind turbine:
Maximum power: 420 W at 65km/h
Propeller diameter: 1.14 m
Start-up speed: 3.00 m/s
Voltage: 12 volts DC 35A
External regulator: microprocessor-based

- 3 photovoltaic solar panels:
Peak power 100 Watt (wp)
Nominal voltage 18.00 Volt
Open circuit voltage 21.24 Volt
Nominal current 5.55 A
Short-circuit current 6.00 A

- 1 solar controller:
Hybrid controller
Charge state determination by Steca / FPS AtonIC (SOC)
Automatic voltage selection
PWM regulation
Multi-stage charging technology
Consumer disconnection based on SOC system
Automatic consumer reconnection
Temperature compensation
Positive or negative grounding at one of the terminals
Integrated data logger
Night light function
Self-checking
Monthly maintenance charge
Overload protection
Deep discharge protection
Protection against reverse polarity of solar panels, consumers, and battery
Automatic electronic fuse
Short-circuit protection for consumers and solar panels
Overvoltage protection on solar panel input
Open circuit protection without battery
Reverse current protection at night
Overtemperature and overload protection
Disconnection in case of battery overvoltage
Graphic LCD display
Simple menu navigation control
Button programming
Manual consumer interruption
Compliant with European standards (CE)
Compliant with RoHS directive
Developed in Germany
Manufactured according to ISO 9001 and ISO 14001 standards

- 1 inverter:
Continuous power 1000 W
Peak power 2000 W
Input voltage 10V - 16V DC
Output voltage 220V - 240V 50 Hz

- 1 set of 2 cables:
This set consisting of 2 cables (male and female) allows you to:

• connect your photovoltaic solar panels directly to your regulator or a terminal block.
• couple and connect in series or parallel all your photovoltaic solar panels.

2-year warranty

OPERATING PRINCIPLE:
The wind turbine and solar panels charge one or more rechargeable batteries that will produce energy to power an inverter that will generate an alternating voltage of 230V.
Warning: a wind turbine or solar panel should never be used directly with an inverter or any other device without a rechargeable battery as a "buffer."

POINTS TO KNOW:
The current required that the hybrid kit must provide to charge the battery depends on the current consumption that the electrical installation will demand during the usage time.
The power (in Watts) that the battery must provide is the total power (in Watts) consumed by the installation (in 230V) and by the inverter itself (negligible for modified sine wave inverters).
Since the solar panel can only provide effective current in sunny weather, up to 10 hours per day at most, it is preferable to consider either a shorter time (6 hours) or a higher current output from the solar panel than the demand.

15085